FIXED - remap bad block on 3rd nand bank

[Phantom]

So I decided to buy another Trident, after the first one i bought was faulty.

This time the Trident powers on and works , the only thing is the 3rd NAND bank wont boot to freeboot, the coolrunner will glitch like normal, then it will stop. I can still boot to Xell

I think the problem is caused by a bad block, but im not sure how to go about remapping it.

This is what I get in 360 flash dump tool

Note: Bad Block ID 0x0040 [Offset: 0x00108000]

========= Analyzed successfully ===========

is that in the first 50 blocks?

ive tried using J-runner to write the nand and still have the same issue.

the other 2 NAND's work fine, any ideas?

cheers

[S4BRE]

viewtopic.php?f=94&t=3168

[Phantom]

I have tried that, J-runner says there are bad blocks, but it dosnt look like it remaps them.

[Phantom]

I had done the above method about 4 times last night, tried it again to see if i would get lucky, and it worked! I didn't touch my wiring or anything, so im not sure whats up with it. All is good now