Jasper 512 CB6751 Try to RGH 2.0 but Console Was Dead

[DjVirus]

I have a jasper512 xbox360 dash version 13599 cb 6751 i was 1st try rgh 1 its not susses Os I will Back to Flash Original Nand.bin The Console Was On
But i will start try second time rgh 2.0 with this console this time was not susses. back to flash original nand.bin and start the console but console was not be start few second latter only 3red light was come i m try meany types to flash the original nand but console was not open still same only 3red light comes
is there any idea how to flash or restart the console ...
[x360avatar][/x360avatar]

[steveo1978]

CB 6751 should be RGH1. Do you know how to check the secondary error code on the 360? When you tried to restore the original nand did you try to erase the nand then reflash?

[DjVirus]

Thanks steveo1978
I will Do First i have erase the full 64 nand block and then restore original nand.bin but same condition any other idea

[steveo1978]

Is it possible that you shorted something when installing the glitch chip? Also did you try and find the secondary error code?

[DjVirus]

So is there no idea to how to back alive the console

[greator]

I didn't mean to hijack but,

This is common problem when someone fail to glitch his xbox, then rewrite original nand, and get 3rod. And my guess that he got the same secondary code as the others, 0022.
BTW DjVirus, you check your secondary error code by holding the sync button and press eject button.
The ring of light will flash rapidly, count how many lights are flashing between each press of eject button (still holding that sync button)
4 lights = code 0
3 lights = code 3
2 lights = code 2
1 light = code 1

You get the error because the nand is not the same as before. Even if you flash it correctly with the original nand you extracted before, somehow it change after flashing. Maybe the nand chip is corrupted or something.
Most solution out there is LDV change, but if we cant get to Xell, how to count the LDV? Even if the LDV is correct, it still got 3rod.
Xbox internal are delicate as hell, You cant go back to stock anymore. All you can do now is try glitching and boot that Xell.

[DjVirus]

4 lights = code 0 this type error was any chance to back to live the console

[Vey]

See if this helps:

http://xbox-experts.com/errorcodes.php

[DjVirus]

This Problem Will Not Only Red ring

[Vey]

Well... when you first try failed and you flash back your original nand it works means that your board is ok. 2nd try failed and after write back original nand and you get 3rod.
Try unsolder everything. Make sure you clean up everything. No flux or anything on the contact points. Solder back your Nand flasher and write back your original nand.

use the +w command in nandpro or "write fusion" in J-runner or whichever software you are using.

After write, desolder the nand flasher. Clean the board up and boot again. See what happens.