live bank not working turned on after update

[jrunner12]

hey guys yesterday i updated the live nand on my matrix trident after i updated it the xbox turned off its self then i power it back on after like 5 seconds middle light is solid red i try'd making a new nand for latest dash then i just get infinite loading green ligh in middle reflashed my original nand red light after 5 second tryd to hold sync and power on to fix any update failure that dident work im lost on what to do

[pbanj]

which bank do you have as your live nand? the green one?

[jrunner12]

which bank do you have as your live nand? the green one?

yes

[pbanj]

how did u tak ethe update? over live or with usb?

[jrunner12]

how did u tak ethe update? over live or with usb?

live then the xbox turned off and i turned it back on my self red ring after 5 seconds but i dont know if it was ment to turn back on its self a nd by me turning it on its corrupted the update

[pbanj]

ya they norm reboot them selves. have you pulled the secondary error code when it red dots?

[jrunner12]

ya they norm reboot them selves. have you pulled the secondary error code when it red dots?

what you mean by that? how do i get the error code

[pbanj]

* Turn the xbox 360 on, and wait till the 3 red lights are flashing.
* Press and hold the sync up button (the small white one), while holding that button press the eject button.
* The LEDs will now blink the first number in the code (as described below).
* Release the eject button and press it again.
* The LEDs will now blink the second number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the third number of the code.
* Release the eject button and press it again.
* The LEDs will now blink the forth number of the code.
* Release the eject button and press it again.
* The LEDs will go back to the 3 red flashing lights.
You should be able to determine the difference between the 3 flashing lights and the error code lights by the rate in which they flash.

Here is how you interpret the LEDs to get the code number:

* All four lights flashing - 0
* One light flashing - 1
* Two Lights flashing - 2
* Three lights flashing - 3


You will for example get an error code like 0102 if you get 4 lights after the first click, 1 after the second, 4 after the third and 2 after the fourth click of the eject button...

that is for the fat but the same goes for the slim

[jrunner12]

Hi mate I've just had to go out I'll be back about quarter past 7 then I'll try it but just so u k now I don't have 3 red lights just the middle led is red

[pbanj]

i know this, thats why i said that is for the fat but it works on the slim, the slim only gives the red dot it is the same as the 3 red lights on the fat