i take no credit for this tut i am just posting it here.
Things you will need:
1: Soldering Iron 2: Soldering Flux 3: An Xbox 360 RF Module (Ring of light board at the front of the Xbox) 4: An old USB cable you don't care about 5: diode not needed, thanks for testing that bobbyblunt 6: Driver for the receiver 7: A brain 8: OPTIONAL: Play and charge kit to sync controller to board anytime you want to
Before we go on, I have to warn you that you MUST sync your controller to the RF Module via Xbox before you move on. You don't have to worry about this if you have a play and charge.
1: Cut the USB with scissors keeping the male part and at least 6 inches of wire. 2: Strip the wire down to the 4 basic wires inside (Red, White, Green, and Black) 3: Strip those wires down to what ever length you feel comfortable with (Cut the red wire the shortest because the diode goes on this one) 4: Solder on the diode to the red wire (Look below for diagram) 5: Now follow this image I made;
6: This should be your final product;
(The black wire is kinda hiding)
7: Lets go to the PC portion. First download the official Microsoft wireless receiver driver from the top and install it normally.
Ive had this for years now but here is the original mod. This one also gives you the option of flashing a pic12f629 with the included hex file which will let you sync the controller while in the pc by just pushing the button on the rf module. I made my own a few years back and its so much better being able to sync controllers at will and more than one if I want, just like its in the 360.