

S4BRE wrote:sorry man, there is no solution at present time.but welcome to The Cove!









sorry to be the bearer of bad news in the other thread, welcome to "Da Cove" & keep in touch we'll definitely keep you updated!ImALegendKiller wrote:Oh well, I'll be sure to keep up with this community as everyone seems to be on the cutting edge, so if anything happens I'll hear about it here first.








check craiglist for your area ( could be someone offering the service), E3 is good for nor models (solder-less) & Progskeet I believe does nand & nor (both solder-less with additional equipment)ImALegendKiller wrote:I know I'd need to downgrade my firmware to get the Cobra working. Does anyone offer that type of service or is it mainly something I'd have to take on on my own? If someone could downgrade for a good price I would be interested.





Users browsing this forum: No registered users and 0 guests