Help Needed Any Body Who Instal Matrix G In Fhat.

[DjVirus]

I M Buy The Matrix Glitch Ic Or Matrix SPI Nand Flasher
And i download The Tutorial In http://infinitymod.com To follow the Instillation Matrix Ic in board Or Dumping And Flashing The Jasper Board
I Have Done Fully correct Like In tutorial
But i Have Power on the Game Only Main Light Are Blink Cant Do Any thing
To See Xell reloaded image In Screen Any Idea To how To Do To Susses
Plz help Us

[kneehighspy]

i had to solder a 0.1uF metalized-film capacitor across ground and the f connection on the glitcher II. after that, boot up on my jasper went from rarely / very slow to 100% and very quick (5-10 secs at most).

[DjVirus]

Thanks Bro For Your help But My Problem Is My Console Cant Boot Xell Reloaded Blue Screen How to Boot It Fast boot Is the 2nd option

[CaLviNx]

Hello


check your soldering for bridges very closely, it Sounds very much like solder point "C" is shorted across to the outer bridge, it is very easy to do this by accident unless you are very careful, the best way I found on these is to tin your kynar wire then bend it into "hook" with the end of the wire pointing down, then place the wire on the pre-tinned point you want solder it onto, then set the wire in place with some hot glue (this saves you holding it with your fingers while attempting to solder it) the "hook" allows your wire to meet the very tiny solder point vertically and thus prevents any chance of bridging/shorting.

with the pre-tinned wire in the correct place you can solder it to the board very quickly knowing it is not going to move or cause a bridge.

i hope that helps

regards